Author Topic: Beginner help please (Read 28001 times) 31 replies

Orientnut · « **on:** May 21, 2020, 10:23:13 PM »

Hi. I'm an amateur with 60L tropical tank. I have a few live plants and some fish who seem OK, but I wanted to be sure my water is OK. So I bought a 6 in 1 test (strips), by Colombo. My readings were chlorine 0.8, PH 7.6, KH 20, GH >21, Nitrate 25 (according to their colour chart system). Are these OK? I don't really understand their instructions on what the readings tell me!? I'm juts looking for reassurance that I've started OK. Really appreciate some guidance as when I look on the Internet for answers, my head starts spinning! Thank you. Paul

Matt · « **Reply #1 on:** May 22, 2020, 12:35:49 AM »

@Orientnut is this a sample of tap water you have tested or tank water? Also so we can advice suitability what fish do you currently have please?

Orientnut · « **Reply #2 on:** May 22, 2020, 07:17:10 AM »

It's my tank water. My tank had been operational for about 10 days following my initial water treatment before adding fish. I have mollys, guppy, tetra, corydoras, Bolivian Ram. Thank you.

jaypeecee · « **Reply #3 on:** May 22, 2020, 08:11:29 AM »

Hi @Orientnut

A few quick thoughts. Aquarium test strips are generally inaccurate. But, your chlorine figure is a bit high. Did you use a tap water conditioner? If so, which one? Have you 'cycled' the tank? If so, please let us have a few details.

That'll do for starters.

JPC

Orientnut · « **Reply #4 on:** May 22, 2020, 08:38:15 AM »

Hi. It was tap water, I then used l❤️VE fish "tap safe". Guy in the store said 48 hrs was enough of a cycle. Starting to think it wasn't from stuff I've read since.

fcmf · « **Reply #5 on:** May 22, 2020, 01:27:40 PM »

An ammonia test is absolutely crucial - buy a liquid-based test one to get accurate results. The key tests are ammonia, nitrite and nitrates - it's important than ammonia and nitrite remain at 0 at all times (any level above that is toxic) and that nitrates are no higher than 20 above tap water nitrate levels.

Hope that helps.

...and welcome to the forum.

Littlefish · « **Reply #6 on:** May 22, 2020, 08:28:26 PM »

Hi @Orientnut and welcome to the forum.

We'll probably be asking lots of questions initially, but this will help us get to know your tank, your situation, and provide suitable advice.

Normally we'd recommend fishless cycling of a tank, which can take several weeks, but it's very common for shop staff to tell people that they can add fish quite quickly after setting up a tank, usually in a matter of days.

I tend to use the API Freshwater Master test kit, which can be purchased online.

Orientnut · « **Reply #7 on:** May 22, 2020, 08:37:54 PM »

Thank you. Yes it does seem like I was given bad advice in the shop and I'm now a little back to front. I'm doing water changes every couple of days

LeakysLab · « **Reply #8 on:** May 22, 2020, 09:04:01 PM »

Hi and welcome

I’m back in the hobby after a break and the guys & gals here are so friendly and helpful. I’m not that far out of the cycle process myself. I would change your water daily (maybe 20-30% depending) in the absence of a api liquid test kit (which I use and recommend) just to keep the Ammonia low as possible until you can monitor it regularly with the test kit.

jaypeecee · « **Reply #9 on:** May 22, 2020, 09:17:38 PM »

Quote from: Orientnut on May 22, 2020, 08:38:15 AM

It was tap water, I then used l❤️VE fish "tap safe". Guy in the store said 48 hrs was enough of a cycle.

Hi @Orientnut

I guess you made your purchases at P@H. I already suspected that but the '❤️' gives the game away.

The "tap safe" just deals with the (fish) nasties in tap water. Cycling a tank needs to be done before any fish or other creatures are added to the tank. So, this is a tricky situation in which you find yourself. In the first instance, I'd be tempted to add 50ml of Tetra SafeStart, which you can get from Amazon UK. You may need more than 50ml so I suggest you buy the most economical size that suits your pocket.

If you try this, there is no guarantee that all your fish will survive - but it can only help. But, the live plants will absorb some of the toxic ammonia and nitrite so this could help. If you do get a bottle of Tetra SafeStart, give it a jolly good shake before adding it to the tank water. And, as @fcmf said, you will need to test for ammonia, nitrite and nitrate. The API Freshwater Master test kit mentioned by @Littlefish would be a wise choice.

Please keep us updated.

Fingers (and toes) crossed!

JPC

jaypeecee · « **Reply #10 on:** May 22, 2020, 09:27:24 PM »

Hi @Orientnut

The following excellent suggestion is something you could start doing as of now. It will buy some time whilst you perhaps follow up on some of our other suggestions:

Quote from: LeakysLab on May 22, 2020, 09:04:01 PM

I would change your water daily (maybe 20-30% depending) in the absence of a api liquid test kit (which I use and recommend) just to keep the Ammonia low as possible until you can monitor it regularly with the test kit.

Please don't forget to use the I❤️Fish "tap safe" on your tap water when doing the water changes.

JPC

Orientnut · « **Reply #11 on:** May 23, 2020, 12:49:54 PM »

OK, so I've done some bits as advised. I now have 0 chlorine, 7.2 pH, 20 KH, >21 gh, 25 Nitrate, 2 Nitrite and 0 Ammonia (liquid test). Everything looks happy in the camp, fish look happy and water nice and clear. Are those numbers generally good to carry on with?

fcmf · « **Reply #12 on:** May 23, 2020, 01:35:06 PM »

Quote from: fcmf on May 22, 2020, 01:27:40 PM

The key tests are ammonia, nitrite and nitrates - it's important than ammonia and nitrite remain at 0 at all times (any level above that is toxic) and that nitrates are no higher than 20 above tap water nitrate levels.

Good that the ammonia test is at 0. As nitrite also needs to be at 0 as it will be otherwise toxic for the fish (even the level of 2 that you have), then larger and more frequent water changes will be required to get that down to 0.

Hope that helps.

LeakysLab · « **Reply #13 on:** May 23, 2020, 02:26:46 PM »

The results look good, but you need to work on Nitrite levels, as fcmf has correctly mentioned you need to increase your water changes. I would suggest min 50% every day then re test to see what the results for all the test and then perhaps change it to 50% every two days depending on results. Remember your de-chlorination and temp is within 0.5°c of your tank.

jaypeecee · « **Reply #14 on:** May 23, 2020, 06:49:48 PM »

Hi @Orientnut

It's always wise to ensure that your tank water is well-oxygenated/aerated. You don't necessarily need an air pump/air stone to do this. Just ensure that the water surface is mildly agitated. You don't want it like a mirror, if you see what I mean. Careful positioning of your internal filter or external filter outlet pipe should take care of this. I would also advise against adding any plant fertilizers at this stage.

What do you intend to do about the Tetra SafeStart? It really is worth adding some to your tank.

JPC

Orientnut · « **Reply #15 on:** May 23, 2020, 07:29:29 PM »

Do I add that in as well as the tap safe solution then?

fcmf · « **Reply #16 on:** May 23, 2020, 07:49:22 PM »

Great advice from Leakyslab about a way forward for water changes. Have you managed to do another water change since then to get the nitrite down to 0? Time is of the essence as far as any ammonia or nitrite is concerned given how toxic they are.

If you already have Tetra Safestart, then you could dose it as well as using Tap Safe.

Orientnut · « **Reply #17 on:** May 23, 2020, 07:52:43 PM »

I did a liquid Ammonia test today and it was zero. I'm now doing daily water changes following advice on here. Thanks

Littlefish · « **Reply #18 on:** May 23, 2020, 08:05:54 PM »

Great to hear that your ammonia is reading zero.
Well done & keep up the good work.

LeakysLab · « **Reply #19 on:** May 23, 2020, 08:14:03 PM »

Quote from: Orientnut on May 23, 2020, 07:52:43 PM

I did a liquid Ammonia test today and it was zero. I'm now doing daily water changes following advice on here. Thanks

Great news, I’d test Ammonia, Nitrite and Nitrate daily too. With Nitrate follow the instructions to the letter if using the API test kit as it would/could give inaccurate results.

Keep up the good work and keep us updated

Subject - Started by	Replies	Last post
HELP -Beginner - fish swimming at top! Started by akirkland The Emergency Room	3 Replies 8769 Views	February 23, 2013, 12:47:48 PM by Sue
good and easy beginner plants Started by graygang Fish Tank Plant Advice	8 Replies 11476 Views	September 02, 2013, 07:45:57 AM by ColinB
Suitable tropical fish for a beginner? Started by Freshwater Welcome to our Tropical Fishkeeping Forum - Please Read	5 Replies 20240 Views	July 18, 2014, 01:27:59 PM by Sue
Good carpeting plant for beginner... Started by Cod_only_knows Fish Tank Plant Advice	9 Replies 9333 Views	March 11, 2015, 10:52:13 AM by Helen
Plants for a beginner Started by GersBantamJR Fish Tank Plant Advice	4 Replies 7738 Views	September 09, 2015, 04:46:57 PM by Richard W
Plants for beginner with new set up Started by greekgypsy Introductions and hello's	7 Replies 9615 Views	May 31, 2017, 06:06:22 PM by greekgypsy
Beginner - New to fish keeping, would like some help and advice :) Started by Alostangel « 1 2 ... 10 11 » New Fishkeepers	205 Replies 85610 Views	November 16, 2019, 06:23:32 PM by Alostangel

Beginner Help Please

Beginner Help Please

Author Topic: Beginner help please (Read 28001 times) 31 replies

Assess Tankmates In The Tropical Fish Community Creator

Topics that relate to "Beginner help please "

Tropical Fish Keeping Help and Advice

Tropical Fish Keeping Help and Advice

Tropical Fish Keeping Product Reviews

Tropical Fish Market Place

Tropical Fish Keeping Community